Manual call points smoke detectors line type compatibility assessment of system components voice alarm control and indicating equipment short circuit isolators input output devices aspirating smoke detectors alarm transmission and fault warning routing equipment.

Manual call point definition. 215 the system and equipment shall be suitably designed to withstand supply. Fire alarm manual call points at the ground oor and rst oor entrances were not working and there were no suitable maintenance systems in force for there detection or re ghting equipment. They should be mounted 14m from the floor and sited where they can be easily seen. A break glass call point is a device which enables personnel to raise the alarm by breaking the frangible element on the fascia.

The call point will be connected on a loop to a fire alarm control panel and when you activate the manual call point what youre. There are options for the inclusion of led status indicators and addressable location or address within the system. A fire alarm call point should be installed at a height of 14m above floor level at easily accessible and conspicuous positions. Mobility impaired person a person with physical mental or sensory impairment either temporary or permanent who requires assistance during emergency evacuations.

Manual call points are normally installed as part of a fire alarm system at regular intervals thoughout a building it is even possible to buy weatherproof manual call points that can be positioned outside. This includes on exit routes at the entry floor. Manual call points are used to initiate an alarm signal and operate by means of a simple button press or when glass is broken revealing a button. Manual call point is the small red box with the glass panel and button.

The pull station is a dual action model equipped with a key lock reset an approved outdoor gasket and an accompanying outdoor backbox. A manual call point is a device which enables personnel to raise an alarm in the event of a fire incident by pressing a frangible element to activate the alarm system. 214 detectors and manual call points shall be connected to dedicated sections of the fire detection system. Breaking the glass and pushing the button will activate the fire alarm.

The bg 12lob pull station is a non coded manual pull station which provides a fire alarm control panel facp with a single alarm initiating input signal. Wip warden intercommunication. Manual call points should be sited on the floor landings of stairways and at exits to open air. There will be an indicator on the monitoring unit for visual indication to locate the call point easily and there should be.